Community Q&A Question: Compatible With Non-adjustable UCA and Panhard Bar?

Asking About: Mustang BMR Lowering Spring Kit (05-14) Drag Race


Compatible With Non-adjustable UCA and Panhard Bar?

I have already installed a BMR non-adjustable Upper Control Arm and Panhard Bar on my 2014 GT.
Are these springs compatible with my existing set up?
from Cebu, Philippines |
0 0

These will work just fine with that setup. The rear end tends to shift to one side as a car is lowered. This varies from car to car and on some of the cars I've had in the past, I had to put an adjustable panhard bar on it to correct the shift, while on others I did not. I would recommend installing the springs and then eyeballing the position of the tire on each side to determine if you will end up needing to get an adjustable panhard bar or not.
from Hewitt |
0 0 Staff Member Post!

Answer This Question

Question About

  • $209.95
    BMR Fabrication Logo