Community Q&A Question: not lowered

Asking About: Mustang J&M Caster Camber Plates - 4 Bolt (94-04)


not lowered

Hello .well since my stang isn't lowered and in the instructions say to use the tall spacer directly on the strut shaft .and idk if i should put it or not.also the say to mark the hole push it all the way to positive (fender side) but it doesn't say if also to the front or the back or in the middle
from palacios |
0 0

Yes, you will need to use the spacer. I'm not sure I follow you on the forward or back portion. Insert the bolt plate from under the strut tower and slide it all the way out toward the fender. The slots on the camber plate are oriented the same as the slots in the strut tower so also slide the plat all the way toward the fender as well. Mark the hole at the edge of the slot that is closest to the fender and drill.
from Hewitt |
0 0

Answer This Question

Question About

  • $183.80
    J&M Products Logo