Does this use the factory M6 driveshaft? How would it work with the M6 PCM? Is there a shifter available?
Asked by Michael T. from Georgetown |
It sounds like you may be trying to put this trans set up into a 2011-2014 car. It can be done but will require custom made parts like cross-member, driveshaft etc. This kit was designed to be used when retro-fitting a coyote engine into an earlier platform like a 79-04 mustang, resto-mod, or early hot rod type application. But to answer your specific questions. The stand alone controller will run the transmission as is and it will not be controlled by the factory PCM and as far as drive shaft goes, you will have to use a n AOD/AODE? or 4R70W specific yoke to mate up to this transmission.
Answered by Scott G.from hewitt |
This post is closed.
Please call 1-866-507-3786
if there is anything else we can do to assist.