Community Q&A Question: Will I be pushing my luck with current mods with a turbo

Asking About: Mustang On 3 Performance Single Turbo Kit (86-93) 5.0


1

Will I be pushing my luck with current mods with a turbo

I'm planning on buying this turbo kit sometime in February. Do you think it's worth getting this kit with my mods I have now or should I swap to different block cause I don't want to be pushing my luck. Here is my mods Rebuilt 302 with edlerbrock performer rpm heads with 202 valves that's ported, flycut pistons,Svo 1.7 roller rockers, comp cams valve springs,BBK 75mm tb,trickflow intake,F303 cam, SR cai,c&l mass air meter,24lb injectors,Mac shorty headers, flowmaster 10 series aka 1 chamber,Offroad H-pipe, b&m shift kit, expody mod,thanks for the help
from Lenoir city |
1 0

3
Accepted Answer
Depending on your overall HP number this may be a tad to much for you in regards to the block holding up. 450-500 is usually the breaking point of a stock 5.0 block. I have seen these block break with less power, and I have seen them make higher numbers and not break. If you want to make serious power(500 HP plus) I would recommend to go with a stronger block first.
from waco |
0 0 LMR.com Staff Member Post!


Answer This Question

Question About