Includes everything you need to replace the small stock air intake system on your 1996-2004 Mustang 4.6L GT. You get the huge 4” JLT pipe, all reducers, clamps, MAF adaptor, Heat shield and filter. This is everything you need to install your kit. Even comes with a all new pipe to MAF reducer that will work with all stock 80mm mass air meters up as big as the 90mm Cobra/Lightning MAF.
If you have a 1996-2001 with an IAT sensor, you will need to drill a 3/4" hole using a pnel or spade drill in the bottom side of the JLT pipe and use the supplied rubber grommet to install the sensor into the JLT pipe.
You can expect 8-12 RWHP with this kit.
Ford has 4 different motor mounts putting the engine in 4 slightly different positions. This can cause this intake to be very tight to the oil fill cap on a small percentage of models and “may” require slight modification of the cap with a dermal or grinder to clear this JLT intake.
JLT has become one of the industry leaders in Mustang & Lightning performance by bringing in some of the highest performance gains with their performance cold air intake systems. By designing and engineering their own products, they have been able to see huge gains in horsepower and torque in developing direct fit air induction kits. Shop Latemodel Restoration for JLT cold air intake kits and oil separators to get the most performance out of your Mustang or Lightning!
Products by Vehicle
Email Me When It's Back In Stock!
Email Me When It Arrives!
Upload a Picture
Upload your own picture of the 96-04 MUSTANG GT JLT RAM AIR INTAKE KIT
Please make sure to hold your device horizontally (like a camera) rather than vertical (like a phone).
By uploading an image, you agree to give LMR.com ® permission to use it in future advertisements and promotions.