LED bulb technology is taking the automotive world by storm! We're proud to offer this 2005-12 Mustang turn signal bulb conversion. Upgrading your factory bulbs to LED bulbs will make sure you're seen in the turn lane. Mustang S197 LED bulbs put off a more pure white light instead of the dingy yellow lights that come from the factory. This ensures you are seen day or night without blinding the vehicles in front of you. These bulbs have excellent heat dissipation, so you do not have to worry about melting or burning your lens.
-3157 Amber x2 Front turn signals
-T10 Amber x2 Front side markers
Turn Signal Resistors
When installing exterior LED bulbs on your 2005-12 Mustang, load resistors must be used on the turn signal bulbs for them to properly flash. The resistance of LED bulbs is much less than with a standard bulb. As a result, your turn signal will “hyper flash” or blink at a very excessive rate similar to when a bulb is blown. The solution is to install a load resistor to simulate the resistance of a factory bulb. Due to variations of wiring harnesses used over the span of these vehicles, we recommend use of a volt meter or test light to determine which wires are the +positive and –negative.
Depending on what vehicle you are working on, there will be two types of bulb connectors you will be presented with. The most common will be a simple 2 wire plug with a positive and negative wire. This is very straight forward as you need to simply use the provided wire taps to connect one end of the resistor to the positive, and one end of the resistor to the negative. The other type of connector you will find is a 3 wire style connector. For this, we recommend using a volt meter or test light to verify which wire is positive and which is negative. Once these are determined, the same process applies. Simply connect one end to the positive and one end to the negative with the supplied wire taps. This process is done on both the left hand and right hand side of the vehicle.