The suspension bushings included with this part can only be lubricated with PTFE grease, also referred to as "Marine Grease". PTFE grease is a very sticky, opaque grease that is water proof and will not degrade the bushing material. If lubed properly at installation, these bushings will not need to be lubricated again. Use of any other grease on these bushings will cause the bushing to fail and any bushing warranty to be voided.
Sway Bar Guide Some of the most common questions asked when it comes to Stang suspension are the Mustang sway bar sizes. This chart gives you the stock Mustang sway bar sizes to assist you in buying the correct replacement bushings or deciding on an upgraded bar. This guide shows you Fox Body, SN-95, New Edge, S19... more
Posted on 6/12/2015
Tools Needed Floor Jack or Lift Jack Stands Ratchet Set Front Bar Installation Removing the factory front anti-roll bar Step 1Lift Vehicle and remove front wheels Step 2Remove the nut and bushing from the end link assemblies at the lower control arms (both sides). Step 3Before proceeding to step 3, suppor... more
Posted on 12/13/2016
Check out our YouTube channel for even more tech tips, installation videos, how-tos, and more. The best place to go for anything Mustang related!
Ford Mustang - 1979 (79) - 1980 (80) - 1981 (81) - 1982 (82) - 1983 (83) - 1984 (84) - 1985 (85) - 1986 (86) - 1987 (87) - 1988 (88) - 1989 (89) - 1990 (90) - 1991 (91) - 1992 (92) - 1993 (93)