SVE Tubular Rear Upper & Lower Control Arm Kit
These rear upper and lower control arms for 1979-2004 Mustang are a quick and cost-effective way to improve the looks and performance of your Mustang's suspension. This rear lower control arm kit includes the proper inner bushing sleeves & installation hardware for the lower control arms to fit both 1979-1998 & 1999-2004 applications.
New Heavy Duty Design
These control arms have been revamped to sustain higher horsepower applications. The welds are beefier and stronger than ever before! The bushings are made from a natural rubber compound to perform great yet offer a smooth ride over poly bushings. The SVE control arms are designed to provide maximum strength and built from heavy wall tubular steel with durable welds. They come complete with a gloss red finish and natural rubber compound bushings. This rear control arm kit comes complete with class 8.8 hardware for an easy & complete installation.
- Bushings must be fully coated in the proper lubricant before installing the control arms.
- Upper 12mm Bolts should be torqued to 60 lb-ft (79-04)
- Lower 12mm bolts should be torqued to 60 lb-ft (79-98)
- Lower 14mm bolts should be torqued to 90 lb-ft (99-04)
These SVE Control Arms are NOT assembled. Due to the difference between the 1979-1998 & 1999-2004 bushings & sleeves, you will need to assemble them according to your application. Don't worry though! Sets for both applications are included with these control arms.
Q: Do they fit 1979-2004 Convertible Mustangs?
Q: Are they strong enough to allow removal of the quad shocks?
Q: Do they come with grease fittings?
Q: Why are grease fittings not included?
A: The particular bushings included in this kit are engineered specifically so that they do not require added grease.
Q: How much grease should I apply to the bushings?
A: A generous amount of the included grease should be applied to all of the bushings.
Q: What grease should I use before I install these control arms?
A: The grease included with the kit.
Q: How much horsepower will these support?
A: Supports up to 400 horsepower.
Q: Will they work on my lowered Mustang?
Q: Do these control arms prevent wheel hop?
A: The bushing material included with these arms are stiffer than the stock rubber bushings. The arms are also much stronger than stock stamped arms. The included bushings and stronger arms both help to eliminate the flex that leads to wheel hop. In most cases you can replace your stock control arms with these and reduce or eliminate wheel hop issues, even if the quad shocks are removed.
-Fits 1979-1993 Mustang - 5.0, 2.3, and SVO
-Fits 1994-1998 Mustang - V6, GT, and Cobra
-Fits 1999-2004 Mustang - V6, GT, Bullitt, Mach 1, Saleen, Roush, and solid axle swapped Cobra.
The suspension bushings included with this part can only be lubricated with PTFE grease, also referred to as "Marine Grease". PTFE grease is a very sticky, opaque grease that is water proof and will not degrade the bushing material. If lubed properly at installation, these bushings will not need to be lubricated again. Use of any other grease on these bushings will cause the bushing to fail and any bushing warranty to be voided.
SVE Rear Control Arm Limited Warranty - Click Here
See what our customers have to say about this product!
Check out customer reviews.