1999-04 Ford Lightning Oil Change Instructions

In this video, Landan explains the full process of how to change the engine oil in a 1999-2004 Ford F-150 SVT Lightning.  This includes the oil viscosity (weight), oil capacity, oil filter, and torque specs.

Product Links

1999-2004 Ford Lightning Oil Change Kit

Tool List

• Microfiber Towels & Brake Clean
• Drain Pan/Bucket
• 16mm Combination Wrench or Socket
• Oil Filter Wrench

Torque Specs

• Oil Filter: 10-12 lb-ft
• Drain Plug: 8-12 lb-ft

Oil Change Instructions

Step 1: Prepare Tools:

• Ensure you have the necessary tools such as a socket set, push pin removal tool, a drain pan, and a funnel.

Step 2: Remove Oil Pan Drain Plug:

• Position your drain pan under your drain plug and using your 16mm socket, slowly rotate the plug to remove it. 
• While oil is draining, take this time to clean your oil drain plug and inspect the gasket. Replace if necessary.
• Once drain is complete and the oil has slowed to a drip, reinstall the drain plug, using a towel and brake clean to clean up any residual oil around the plug.

Step 3: Remove The Oil Filter

• Place your drain pan under the oil filter to catch any oil that may spill out when removing.
• Using your hands or an oil filter wrench, remove the oil filter and allow the oil to come to a slow drip.

Step 4: Prepare New Oil Filter:

• Clean the O-ring of the new oil filter with brake clean and a microfiber towel.
• Blow out any debris from the filter.
• Pre-oil the filter and lubricate the O-ring with a thin film of fresh engine oil.

Step 6: Install New Oil Filter:

• Screw on the new oil filter until it makes contact with the oil filter adapter.
• Tighten hand-tight, then give it a little extra turn.
• Check for any leaks or drips.

Step 7: Fill Engine with Oil:

• Open the hood and locate the oil fill cap.
• Use a clean funnel to pour the appropriate amount of oil into your engine. Replace cap and check for drips.

Step 8: Check Engine Oil Level

• Verify that there are no leaks from the oil pan and filter.
• Start the vehicle and let is idle for about 5 minutes.
• Cut the vehicle off and check your oil dipstick tube to verify you have added the correct amount of oil.