How To Change Oil In 2018-2023 Mustang GT

We know, an oil change is one of the simplest things a Mustang owner can do, and should know how to do. However, we are all about teaching everyone the correct method of changing oil in a Gen 3 Coyote to make the process as quick as possible. Follow along as Landan walks you through the easy steps to change your 2018-2023 Mustang GT oil.

Product Links

2018-2023 Mustang GT Oil Change Kit

Tool List

• Lift or Jack & Jack Stands
• Microfiber Towels
• Cardboard, Aluminum Foil, or Form-a-funnel
• Brake Clean
• 15mm Socket or Wrench
• 7mm Socket
• Push Pin Removal Kit
• 1/4" Socket Wrench
• 3/8" Socket Wrench
• 3/8" Torque Wrench

Torque Specs

• Oil Filter Stage 1: 44 lb-in
• Oil Filter Stage 2: 180-degree rotation

Oil Change Instructions

Step 1: Prepare Tools:

• Ensure you have the necessary tools such as a socket set, push pin removal tool, a drain pan, and a funnel.

Step 2: Remove Oil Pan Drain Plug:

• Position your drain pan under your drain plug and slowly rotate the plug to remove it. 
• You may need to use pliers to get leverage to loosen your drain plug.
• While oil is draining, take this time to clean your oil drain plug and inspect the o-ring. Replace if necessary.
• Once drain is complete and the oil has slowed to a drip, reinstall the drain plug, using a towel and brake clean to clean up any residual oil around the plug.

Step 3: Remove Lower Close Out Panel:

• Using a 7mm socket, remove the 4 bolts holding the close out panel in place.
• The front of this panel is held in by clips, so simply pull down to release the tabs.

Step 4: Remove Old Oil Filter:

• Locate the oil filter.
• Optional: Place cardboard around the bottom of the oil filter adapter to divert any oil into your catch can.
• Loosen the oil filter and let the oil drain into the pan.
• Wipe the area around the oil filter adapter.

Step 5: Prepare Oil Filter:

• Clean the O-ring of the new oil filter with brake clean and a microfiber towel.
• Blow out any debris from the filter.
• Pre-oil the filter and lubricate the O-ring with a thin film of fresh engine oil.

Step 6: Install New Oil Filter:

• Screw on the new oil filter until it makes contact with the oil filter adapter.
• Tighten hand-tight, then give it a little extra turn.
• Check for any leaks or drips.

Step 7: Reinstall Lower Closeout Panel:

• Reverse the removal steps for the lower closeout panel.

Step 8: Fill Engine with Oil:

• Open the hood and locate the oil fill cap.
• Use a clean funnel to pour 10 quarts of 5W20 oil into the engine.
• Replace the oil fill cap, start the car and allow to run for 5 minutes. Shut the car off and check oil level with dipstick.

How To Reset Oil Life

Step 1. Press the start button to turn the key on with your foot OFF the pedals. (Key On, Do Not Start The Vehicle)



Step 2. Press the gear button on the right side of the steering wheel.



Step 3. Navigate To Advanced Settings, Click OK. Click Vehicle, Then Click Oil Life Reset. Follow The Instructions To Hold Down The OK to Reset.