Anderson Power Pipe
- Increased Air Flow
- Cooler Air Inlet Temps
- 4" Mandrel Bent Construction
- Ceramic Coated Inside & Out
- Re-Locates Air Filter & Air Meter Outside The Engine Compartment
What's in the Box
- (1) Power Pipe Assembly
- (1) Straight Rubber Connection Tube
- (1) 90º Rubber Connection Tube
- (4) Hose Clamps
This Anderson Naturally Aspirated Power Pipe® is designed for Pro-M 77/80 shorty meter, Abaco 85mm DBX, or virtually any MAF with a 4" housing, on 1986-1993 Mustang 5.0L applications. Anderson Power Pies feature Mandrel bent 4" Ceramic coated (inside and out) pipe that puts the mass air and air cleaner in the inner fenderwell for a cooler intake charge for added H.P. Additional benefits of the Power Pipe is better driveability for Mustangs with bigger profile camshafts.
AFM Normally Aspirated Power Pipes were developed because of the need for higher volume, better flowing intake pipes needed with the higher RPM 4.6/5.0 and the bigger cubic inch 347/408. With the volume of air these engines need, the small factory rippled intake pipes are too restrictive and the cold air intake pipes are too small of volume. They rely on the cooler intake charge to gain H.P., which cannot be chassis Dyno tested. AFM dyno's each Power Pipe® to verify H.P. gains. The mass air is in the inner fender well, but we do not rely on the cooler intake to make the extra H.P. We do it in design and testing.
Comes with an inlet to fit 75mm and smaller throttle bodies.
Does NOT include Mass Air Meter or Air Cleaner.
Will fit virtually any MAF with a 4" housing
Anderson recommends a filter 8-10" in length and no more than 6-1/2" in width.
1986-1993 Mustang 5.0
This product is intended for off-road use only, and is not legal for use in emission restrictive states. Off-Road Disclaimer
Anderson Ford Motorsports Warranty - Click Here