Allows Aftermarket Throttle Body On Your 1986 AOD Mustang
Includes Locking Washer
Sold As Each
What's in the Box
(1) Throttle Lever Stud
All Needed Hardware
This is the small flat faced stud located on the throttle lever that the AOD Throttle Valve (TV) Cable attaches to. If you put an aftermarket Throttle Body on your 86 Mustang with an AOD, you need this stud! Comes with lock washer and attaching nut.
Service through the web site was excellent! Only down side to this is I bought a bbk 70mm throttle body kit and the grommet on the TB was to large to fit into the tv cable. I order this part to solve my issue to no surprise the washer included in the kit along with the bolt didn't clear the throttle body leaving it still open. I had to cut the plastic grommet off and then purchase washers to make the Clearance gap as shown in the picture. Happy with the part but wish it wasn't so much of a hassle for install on a TB.
For over 100 years Holley has been proven to be an industry leader by providing Mustang enthusiasts and racers with the high performance carburetors , intake manifolds, cylinder heads, and other quality performance components needed for today's competition. Holley's performance Mustang parts are perfect for any daily driven or high horsepower race car.
This is my 1986 Mustang convertible. It is my daily driver and I drive it everywhere, it has a 3.8 v6 with a c5 transmission and I know of very few of these cars that have been rebuilt. I got the car ...