Saleen - Hatchback by Daniel Carpenter Reproductions

Replace your worn or damaged 1987-1993 Mustang GT 3rd brake light lens assembly with this direct replacement lens and hardware kit by DCR!

Item #LRS-13613BK

Everyday Low Price: $29.95

Out of Stock

This item is returnable. Details

× close

Images

Ford Mustang - 1987, 1988, 1989, 1990, 1991, 1992, 1993
Sub Models: GT, Cobra, Saleen
Body Styles: Hatchback

WIll ALSO fit 1993 Cobra and Saleen Spoilers
Will NOT fit GT convertibles
Will NOT fit LX Rear Spoiler

Benefits

Direct Replacement
Restores Exterior Of Your Mustang
Correct Install Hardware

Features

Sonic Welded For Tight Seal
Red OE Style Lens
Corrosion Resistant Hardware

What's in the Box

(1) 3rd Brake Light Lens Assembly
(2) 3rd Brake Light Screws
(2) Speed Nuts

Mustang GT 3rd Brake Kit

Replace your worn or damaged 1987-1993 Mustang GT hatchback 3rd brake light lens assembly with this direct replacement lens and hardware kit by DCR! Over the years, the 3rd brake light lens on your 1987-1993 Mustang GT hatchback can end up faded, cracked, or broken. To get your Fox Body looking better and your 3rd brake light functioning properly again, pick up this replacement 1987-1993 Mustang GT hatchback 3rd brake light lens assembly. This assembly is an exact reproduction of the factory light assembly for a perfect fit and fully restored look. This Mustang 3rd brake light is sonic welded for a tight seal to prevent moisture from entering the assembly. Also included are two mounting screws and two nylon clip nuts to properly secure the 3rd brake light to your Fox Body GT hatchback.

Installation Notes

This brake light lens assembly mounts in the factory position and requires the use of your original wiring.
The 1" screws will be utilized to install this third brake light.

Application

Fits 1987-1993 Mustang GT Hatchback

Daniel Carpenter Restoration Warranty - Click Here

California Residents:

WARNING: Cancer and Reproductive Harm- www.P65Warnings.ca.gov

About This Brand

Daniel Carpenter Reproductions has been a trusted name in the Mustang community and known for producing high-quality products with factory fit and finish. Many of their products are made with Ford original tooling and manufactured in the USA while others are built to OEM specs and are an exact reproduction of the original. With a wide variety of restoration products ranging from exterior weatherstrip to interior trim, Daniel Carpenter Reproductions has the products you need to properly restore your Mustang. Shop our selection of Mustang Daniel Carpenter Reproductions products here at LMR.com!