Ford Lightning Weatherstrip Kit
If your 1993-1995 Ford SVT Lightning's weatherstrip has seen better days, it's the perfect time to pick up an all in one weatherstrip kit to seal off your F150. This SVT Lightning weatherstrip kit includes all of the needed weatherstripping to replace all of the door/body/window seals on your truck.
Kit Includes:
(1) Inner & Outer Door Belt Weatherstrip Kit
(2) Run Channel Weatherstrips
(2) Door To Body Weatherstrips
(1) LH Door Vent Window Seal
(1) RH Door Vent Window Seal
Application
- Fits 1993, 1994, 1995 Ford F150 SVT Lightning
Check out our YouTube channel for even more tech tips, installation videos, how-tos, and more. The best place to go for anything Mustang related!
Published on 2018-05-23 Through the years, Ford SVT Lightning interior parts have started to wear and tear leaving you with a worn out look in your truck. Late Model Restoration has you covered with interior restoration and upgrade parts to get the inside of your truck looking brand new.
Choose from new floor carpet, floor mats, seat upholstery, dash parts, steering column components, interior lighting, door parts, rear view mirrors, gauges, headliners, paint, and much more! Find everything you need to get your Ford Lightning interior back to great shape at LMR.com!
Published on 2018-05-23 SVT Lightning Door Belt Weatherstrip. Eliminate wind noise and moisture from entering the cab of your SVT Lightning with new inner and outer door belt weatherstrip! This kit includes inner and outer weatherstrips for both driver and passenger side. These tend to wear out and become brittle over time causing leaks and wind noise. Manufactured to factory specs, these pieces are a direct fit and require no modification.
Published on 2018-05-24 SVT Lightning Door to Body Weatherstrip. The door to body weatherstrip is the most commonly worn out piece of weatherstrip on your SVT Lightning. When this piece is worn out, wind and moisture can enter the truck. These 1993-1995 Ford F-150 Lightning door to body weatherstrip seals fit both driver & passenger side. The door to body weatherstrip runs around the frame of your door in a complete cycle and each end touches the other. They are trim to fit and simply install over the factory pinch weld so no adhesive is needed.
Installation Note: - In the corners, try not to stretch out the weatherstrip. If you are getting a kink, pull the weatherstrip back off and try to compress it into the bend. Sometimes lightly heating the weatherstrip with a hair dryer helps ease this situation.
Published on 2018-05-24 SVT Lightning Run Channel Weatherstrip. This is a run channel weatherstrip for your 1993-1995 Ford SVT Lightning. This weatherstrip will fit both the left or right side of your Lightning. This is the weatherstrip that your door glass rides in when traveling up and down inside the door frame. It also seals the top of the glass when it is rolled up completely. These can become brittle and wear down causing severe wind noise or moisture to enter the cab. Ensure your SVT Lightning is sealed up tight with this direct replacement weatherstrip!
The wheel size is the diameter of the wheel, in inches, not counting the tire.
Modern tires in North America have several other measurements associated with their size.
A tire designated as a "225/70R14" denotes a tire with the following dimensions: width of tread: 225 mm; ratio of tire height to width: 70 percent; rim diameter: 14".
Therefore a 185/70R14 has the same rim diameter and aspect ratio, but a smaller overall diameter and narrower tread face than the 225/70R14.
Wheel Width
Wheel Backspacing
The easiest way to measure backspace is to lay the wheel face down onto the ground so the backside of the wheel is facing up.
Take a straight edge and lay it diagonally across the inboard flange of the wheel. Take a tape measure and measure the distance from where the straight edge contacts the inboard flange to the hub mounting pad of the wheel. This measurement is the backspace.
The photo below shows three wheels with 2", 3", & 4" backspace.
Wheel Bolt Pattern
The bolt pattern or bolt circle is the diameter of an imaginary circle formed by the centers of the wheel lugs. Bolt patterns can be 4, 5, 6, or 8 lug holes. A bolt circle of 4x100 would indicate a 4 lug pattern on a circle with a diameter of 100mm.
The diagram indicates the proper measuring methods. 6 lug wheels are measured like the 4 lug wheels.
Wheel Offset
The offset, measured in millimeters, can be negative or positive, and is the distance from the hub-mounting surface to the rim's true centerline. A positive offset means the hub-mounting surface is closer to the outside edge of the wheel; a negative offset means the hub-mounting surface is closer to the inside edge of the wheel. Offset affects the scrub radius of the steering and it is advisable to stay within the limits allowed by the vehicle manufacturer. If tires are fitted which are significantly wider than those specified by the manufacturer, a compromise may have to be adopted whereby a wheel with less offset is used to prevent the tire rubbing on the suspension.
Wheel Centerbore
The centerbore of the wheel is the opening in the middle of the wheel, surrounded by the lug holes. This opening helps to center the wheel to the hub. Its diameter is typically measured in millimeters (mm) and varies in size depending on vehicle application. Manufacturers approve up to a 1% variance in tolerance to pass wheels during inspection.
WARNING: Cancer and Reproductive Harm- www.P65Warnings.ca.gov
