For our faithful YouTube Subscribers, you have seen this "won't start" or "doesn't run" Fox Body turned it into a running "gem"! We recently purchased "Project Blue Collar" and decided the best way to celebrate was to put it up on the dyno! For those who haven't seen this car from our channel, be sure to check out our YouTube Playlist covering the build series of this car!
Jump To:
Dyno Numbers & Photos
← Swipe For More "Project Blue Collar" 1988 Fox Body Mustang Photos →
Dyno Technical Data
- 347 cu in engine
- Holley 600 CFM Carburator
- Carburator Spacer
- Dual Plane Intake Manifold
- Aluminium Cylinder Heads
- Underdrive Water Pump & Crank Pulley W/ Electric Fans
- Long Tube Headers, Off-Road Mid Pipe with a dumped exhaust
- T5 Transmission (Pull is made in 4th gear | 1:1 Ratio)
- Aluminium Drive Shaft
- 3.73 Rear End Gears
- 17" Cobra Style Wheel W/ 275/40/17 Rear Tire
- 93 Octane Fuel
- Timing is set at 14 degrees
Dyno Results
Finally, we see how much Project Blue Collar makes on the dyno! This 1988 Fox Body Mustang made 294 RWHP st 5,600 RPM and 293 RWTQ at 4,000 RPM.
Want to learn about the history of Project Blue Collar? Be sure to check out the YouTube Playlist to learn more. As always, keep a lookout for more dyno articles and videos right here at LMR.com.