Tools Needed
- Floor Jack or Lift
- Jack Stands
- Ratchet Set
Front Bar Installation
Removing the factory front anti-roll bar
Step 1
Lift Vehicle and remove front wheels
Step 2
Remove the nut and bushing from the end link assemblies at the lower control arms (both sides).
Step 3
Before proceeding to step 3, support the anti-roll bar, as it will drop freely out of the vehicle after the next step.
Step 4
Loosen and remove the bolts holding the anti-roll bar bushing brackets to the chassis (both sides). Do not discard these brackets or bolts, as they will be needed to re-install the Eibach Anti-Roll Bar.
Step 5
Remove the stock Anti-Roll Bar
Installing the Eibach front anti-roll bar
Step 1
Lubricate the new Eibach Middle Bushings with the lubricant supplied
Step 2
Position the new middle bushings (both sides) on the eibach anti-roll bar in the same position as they were installed on the factory bar.
Step 3
Align the middle bushings (both sides); install the factory brackets by loosely tightening the bolts to the chassis.
Step 4
It is important at this time to verify the bar is centered left to right.
Step 5
Loosely fit the NEW end links to the anti-roll bar arms and then to the control arm (both sides). DO NOT tighten at this time.
Step 6
Now tighten the bolts holding the middle bushings and bracket (both sides) to factory torque specifications.
Step 7
Go back and tighten the end link assemblies to the anti-roll bar and the lower control arm to the factory torque specifications. DO NOT OVER TIGHTEN, as the is will crush the end link bushings, resulting in poor performance and premature wear.
Rear Bar Installation
Removing the factory rear anti-roll bar
Step 1
Lift Vehicle and remove rear wheels.
Step 2
Locate the anti-roll bar where it connects to the lower trailing arms (both sides)
Step 3
Before proceeding to step 3, support the anti-roll bar, as it will drop freely out of the vehicle after the next step.
Step 4
Loosen and remove the bolts that connect the anti-roll bar to the lower trailing arms (both sides).
Step 5
Remove the stock anti-roll bar.
Removing the factory rear anti-roll bar
Step 1
Lift the Eibach Rear anti-roll bar into position in the vehicle and install the provided bolts and nuts (both sides).
Step 2
Tighten the hardware to the factory torque specifications.
Instructions provided by Eibach Suspension
