Benefits
- Prevents Front Bumper Tabs From Popping Out
- Restores Proper Bumper To Fender Alignment
- Simplifies Front Bumper Removal
- Cost Effective Solution
Features
- Billet Aluminum Construction
- Sleek, Low-Profile Design
- Stainless Steel Hardware
- Black Zinc Coating
What's in the Box
- (4) Washers
- (4) Retaining Nuts
- (2) Quick Push Fasteners
- (2) Threaded Mounting Studs
- (2) Quick Push Fastener Retaining Nuts
SVE S550 Mustang Front Bumper Repair Kit
Reattach the broken front bumper tabs on your 2015-2017 S550 Mustang by installing SVE's front bumper repair kit! From the factory, your Mustang's front bumper cover was secured on each side by flimsy plastic tabs. After numerous removals of the front bumper, these tabs begin to weaken and break off. This poor design led to a major complication where the bumper tabs would 'pop' out on each side, causing an unsightly fitment between the fender and the front bumper. To resolve this troublesome issue, SVE has developed a cost effective repair kit to avoid the body shop while simplifying the removal and installation of the front bumper.
SVE Quality
Specializing in providing problem solving solutions for late model Mustangs, SVE's products are built to last and this front bumper repair kit is no exception! The quality of research and development can easily be seen by the sleek, low profile design of the quick push fasteners. Manufactured with durability in mind, these fasteners feature a billet aluminum construction and are finished with a black zinc coating for corrosion resistance. Utilizing a factory square hole on the fender to bumper bracket, SVE provides two stainless steel studs and the corresponding retaining hardware to correctly secure the push fasteners that hold the bumper tabs in place. With years of Mustang knowledge and experience, SVE is proud to present this solution based kit to ensure your S550 Mustang front bumper tabs never pop out again!
Installation Note- Drilling a hole in your front bumper is required!
- Measure twice, drill once! Make SURE the panel alignment is where you want them BEFORE drilling!
- Drilling a hole in the center of the factory plastic bumper brackets is required in order for the quick push fasteners to sit flush.
- It is HIGHLY recommended that blue thread locker compound be applied to the retaining hardware upon final adjustment.
Application
Fits 2015-2017 Mustang
SVE Products Limited Warranty - Click Here
WARNING: Cancer and Reproductive Harm- www.P65Warnings.ca.gov
