1979-26 Mustang SVE Jack Pad by SVE Special Vehicle Equipment ®

1979-2026 Mustang SVE Jack Pad
Safely jack your Mustang up without damaging the pinch welds or frame rails with Special Vehicle Equipment's® billet aluminum jack pad! One of the most common areas to lift your Mustang is via the pinch welds, located below the rockers. After numerous improper attempts at jacking up your Mustang, the pinch welds can become warped or crushed. To prevent this common issue, SVE is proud to offer this premium, solution-based item to ease the maintenance of your Mustang, provide a safe jacking point, all while protecting the factory pinch welds in the process.

High-Quality Materials
Designed and manufactured in the USA with the highest quality materials, SVE's jack pad kit features a billet aluminum construction with an 8mm opening between the side gussets in order to provide the structural support needed to evenly disperse the weight of your Mustang onto your hydraulic jack. The jack pad has a deep groove and is pre-installed with strong neodymium magnets to ensure a strong holding capacity while positioning your jack. Completed in a black anodized finish for the ultimate corrosion resistance, this jack pad is engraved with SVE's signature logo for the ultimate stamp of approval for this problem-solving solution!

Product Note

• SVE does NOT recommend placing this jack pad in the center of the pinch weld and lifting one side of the vehicle off the ground as certain year model Mustangs pinch welds are not as strong.
• These are NOT intended to stay on the vehicle. They are to be used with a lift or a floor jack and then removed.
• These jack pads were designed to be used with a floor jack that has a flat top, you may need to make a spacer if your jack is an older model.
• After the jack pads have been used several times, you will begin to see the signs of normal wear and tear.

SVE Products Limited Warranty - Click Here