details transcript

Fox Body Mustang Ignition Coil Cover Install

Is the ignition coil cover on your Fox Body Mustang missing or damaged? Watch as Jmac shows you just how easy it is to replace your coil cover in this installation video. Installing a new cover will take you less than 15 minutes and best of all it is manufactured from the Ford Original Tooling! That means you get the ultimate in fit and finish!

Clean up your engine bay by hiding that mess of wiring around your Mustang ignition coil! You can pick one up in the link below. Don't forget to pick up a hardware kit and new performance ignition coil from MSD or Performance Distributors to finish off your installation!

Mustang Ignition Coil Components

Show More Show Less

Viewing this install and using the information shared is subject to the terms set forth here - View the LMR Install Instructions Disclaimer.

FOLLOW: mustang , 79 93 mustang , fox body , video , installation , engine , ingition

How To Install Fox Body Mustang Ignition Coil Cover Install

Installation Instructions

Slide the coil cover into place by engaging the bottom tabs with the frame rail.

Fox Mustang Ignition Coil Cover Install - Fox Mustang Ignition Coil Cover Install

Line up and insert the push pin on the the strut mount tab.

Line up and insert the push pin on the fender tab.

1979-1993 Fox Body Mustang Ignition Coil

Restore or increase the performance of your Fox Body's ignition system with a new 1979-1993 Mustang ignition coil. Choose from replacement or performance!

About the Video

Fox Body Mustang Ignition Coil Cover Install (86-93) - 5.0Resto

Check out our YouTube channel for even more tech tips, installation videos, how-tos, and more. The best place to go for anything Mustang related!

Published on 2013-03-06
From the factory, Ford covered the Fox Body Mustang ignition coil. It hides the ignition coil and all the wiring around it. Not only did this protect the wires and coil from the elements but it made the engine look nice and neat by hiding this mess of wiring.

Often these are broken and cracked due to engine heat and weathering. The rest of the time they are missing because someone tossed them in order to show off an upgraded MSD or Screamin' Demon ignition coil.

Installation is super easy and should take you no more than 10 mins to remove the old one and install the new Mustang Coil Cover. If you are missing the installation hardware, LatemodelRestoration.com carries the 5.0Resto ignition coil cover hardware kit.

Transcript
JONATHAN MCDONALD: Very commonly missing part on '86 to '93 Mustangs is the coil cover. Now this coil cover completely hides all the coil and the wiring that goes to the starter solenoid. Now our 5.0 Resto brand coil cover is identical to the original, has the correct mounting tabs, even has a notch cut out for the coil wire to pass through. Installation is extremely simple and will take you less than a minute. And it will greatly improve the appearance of your underhood.

Slide the coil cover down into place engaging the tabs on the bottom with the frame rail right above the display bar mount. Then line up your tabs and the middle one right behind the brake master cylinder on the strut tower. The top one with the hole right next to the fender-- use our 50resto push pin kit to attach the coil cover to the car and you're done.

All right, that literally took seconds to install and completely hides all the nasty wiring behind here. Now for more Mustang restoration and renewal parts, check out latemodelrestoration.com.