Benefits
- Reduced Wheel Hop
- Increased Traction
- Quicker 60 Ft Times
Features
- Black Powder Coated Finish
- Bind-Free 3-Piece Poly-Ball Bushings
- Tubular Design
What's in the Box
- (2) Lower Control Arms
- (2) Upper Control Arms
- 3-Piece Poly-Ball Bushing Kit
Mustang J&M Rear Control Arm Kit
Improve traction by reducing wheel hop with this 1999-2004 Mustang rear control arm kit from J&M! The factory stamped steel control arms are not completely boxed. This allows too much flex under load. J&M helps solve this problem with their tubular upper and lower control arms. J&M constructs this kit with tubular steel for strength that doesn't flex under load. When the control arms don't flex, you experience an improved launch to increase traction for the best performance possible.
3-Piece Poly-Ball Bushings
The Poly-Ball bushing combination in this control arm kit incorporates a very hard inner polyurethane ball which is surrounded by soft socket outer cups. This combination allows the bushing to articulate like a spherical bearing during cornering. The hard inner ball does not allow the bushing to deflect giving you great traction during acceleration.
Fitment Note
Will NOT fit 1999-2004 Cobra IRS
Application
Fits 1999-2004 Mustang GT/V6/Mach 1 Bushing Lubrication
- The suspension bushings included with this part can only be lubricated with PTFE grease, also referred to as "Marine Grease". PTFE grease is a very sticky, opaque grease that is water proof and will not degrade the bushing material. If lubed properly at installation, these bushings will not need to be lubricated again. Use of any other grease on these bushings will cause the bushing to fail and any bushing warranty to be voided.
J&M Products Warranty - Click Here
WARNING: Cancer and Reproductive Harm- www.P65Warnings.ca.gov
