- Replaces Weak Factory Alternator
- Increased Amperage Output
- Internally Regulated
- SVE Quality
- Black Finish
- 200 AMP Fuse
- 2.55-Inch Pulley
- 4 GA Power Cable
What's in the Box
- (1) 130 Amp Alternator
- (1) Voltage Regulator Plug
- (1) Stator Plug
- (1) Attaching Bolt
- (1) Attaching Nut
- (1) Power Wire Upgrade
- (3) Butt Crimp Connectors
SVE 130 Amp Alternator Upgrade Kit
Increase charging power in your 1986-1993 Mustang with this black SVE 130 amp alternator upgrade kit! 1986-1993 Mustang stock alternators suffer from small wiring and low amperage output. Add underdrive pulleys while running your accessories and you'll likely see the lights dim and the battery gauge drop. Throw an electric cooling fan into the mix and the stock alternator simply can't keep up. This SVE alternator upgrade increases amperage output from 75 to 130 to power all of your accessories!
Our 130 amp SVE alternator is 100% brand new, no core charge, and carries a Limited Lifetime Warranty. This alternator is from the internally regulated 3G series, includes the correct pulley (installed), and produces 75-100 amps at idle when used with the stock crank pulley and the included alternator pulley. The idle output of the SVE alternator meets or exceeds the peak output of the stock alternator! SVE's alternator is rated at 130 amps continuous output but is capable of producing 160+ amps at peak. A dyno sheet, specific to every alternator, is included with every alternator to verify these stats.
4 Gauge 3G Power Wire Kit
This kit includes a complete upgrade to the main power feed wire from the alternator to the vehicle. The OEM wire from the alternator to the vehicle was not designed to carry the added load of higher amperage alternators. Using this large (#4 Gauge) wire kit will add the safe carrying capacity needed for lengths up to 10 feet. When using our high output alternators you MUST
upgrade this cable to retain warranty coverage. It also includes noise suppression for aftermarket radios.
Alternator Max RPM
The maximum Alternator shaft RPM is 16,000 RPM. This RPM is calculated by taking the crank pulled diameter and dividing it by the alternator pulley diameter. Then multiply it by the max engine RPM.
Underdrive Pulley Note
Charging performance is tested with stock size accessory drive pulleys. Underdrive pulleys will lower the alternator RPM thus preventing optimal charging at engine base idle speed.
SVE Products Limited Warranty - Click Here