J&M Lower Control Arm & Adjustable Panhard Bar Kit
Add some stability, launch harder & get more traction to the rear end of your 2005-2014 Mustang with this J&M Lower Control Arm & Adjustable Panhard Bar Kit! J&M's street tuned rear lower control arms will help keep your 2005-2014 Mustang's rear end planted even under high RPM launches. Their exclusive design eliminates undesirable handling characteristics of the S197 suspension without compromising on cornering. Improve handling on your S197 Mustang and eliminate the unwanted flex and twist commonly found with the poorly designed factory panhard bar. The J&M Mustang Adjustable Panhard Rod keeps the rear axle located in the optimum position under the rear of the car, dramatically improving cornering and overall handling. You can easily fine tune your suspension with the Panhard bar installed on your S197 Mustang just by turning a wrench, no need to remove it to make adjustments.
If you lower your S197 Ford Mustang, you need this kit! By nature, a Mustang Panhard Bar will alter rear end position as ride height changes. This makes it necessary to use an Adjustable Panhard Bar when lowering your vehicle as it allows you to re-center the rear end. Adjustable Panhard Bars also become a "must-have" part if you are trying to fit the widest tires possible in the wheel well.
-Fits 2005-2014 Ford Mustangs
The suspension bushings included with this part can only be lubricated with PTFE grease, also referred to as "Marine Grease". PTFE grease is a very sticky, opaque grease that is water proof and will not degrade the bushing material. If lubed properly at installation, these bushings will not need to be lubricated again. Use of any other grease on these bushings will cause the bushing to fail and any bushing warranty to be voided.
J&M Products has been a world leader in the design and manufacturing of automotive suspension since 1996. Their products are built in our modern production facilities, years of research and a constant commitment to innovative technologies and manufacturing methods.
J&M Products' new product development is a result of our commitment to performance products that deliver results. Each new component must pass both quality and performance evaluations prior to a manufacturing commitment.
The flexible manufacturing process provides large volume production of specialty components for your Mustang or Lightning as well as accommodating the complexities of the small run direct-fit components. Their modern factory incorporates highly precision automated methods with the capabilities of holding a tolerance of + or - .0001 inches to insure product consistency at the highest quality levels and competitive pricing.
Shop LatemodelRestoration.com for your J&M caster camber plates, stainless steel brake lines, lower control arms, and other high quality Mustang components.